home *** CD-ROM | disk | FTP | other *** search
- GMega / K11 Section
- -------------------
-
- * GMega / K11 Section
- - parameters
-
- * Before loading data from the
- instrument BANK SEL must be
- set to USER
- - Press the SYSTEM button
- - Move to SNGL BANK SEL
- - Set the bank to USER
-
- * Under the SYSTEM button, also
- ensure that the following are
- set:
- UNIT RCV EXCL = ON
- UNIT CH = Driver Comm Ch
- (set the Comm Ch to UNIT CH)
-
- * For best results, it is recommended
- that ports IN A and OUT A are used
- for SysX transfer
-
- * IMPORTANT! The GMega and K11 both
- have an extremely nasty SysX
- implementation. As a result, it is not
- possible to load a Group as you normally
- would with other instruments. In order
- to create a Group you should follow
- these steps:
- - highligh GMEGA or K11
- - click on "N.Edit" to create a new group
- - repeat the following steps for each
- entry in the new Group
- - right click on the entry
- (Section, Patch Bank, etc)
- - choose "Receive from Instrument" from
- the popup menu
- - you may have to wait some time for
- the program to start receiving the data.
- This is normal.
- - You will also see that the instrument
- continues to send after the program has
- finished receiving data. Before loading
- the next block of data, either wait until
- the instrument stops sending or reset
- the instrument by turning it off and then
- on again.
- - once all of the data has been loaded save
- the Group to disk
- - you have now loaded and saved a Group
-
-
-
-